S Scania Multi 📌 unpin — ▢ ×
Pin a chassis:
Home Vehicle Parts Information Workshop Diagnostics Search Back Forward Help
V
DTC › AUS4 AUS4 / 0005

DAB Antenna short circuit to Ubat

â–¶ How to fix

Disconnect the DAB antenna power cord (black connector) from the antenna (U26). Restart the infotainment system and check if the DTC remains active. If so, the error probably depends on the antenna. Disconnect the antenna. Allow the antenna's power cord to be connected to the on-board electronic controller. Measure the wiring between ground and signal. The measurement result should be between 8 and 16 V. Check the short circuit for the remaining wiring between the antenna and the electronic controller. If the fault is not in the wiring or antenna, there is probably an internal fault in the electronic control unit.

What you'll see

The infotainment system cannot receive signals from the antenna. No reception on the DAB radio.

System reaction

DAB might not work as expected

Diagnostic depth

Detection

If parameter System_DAB = on and DAB Antenna is short circuited to UBAT. When the current at the antenna > 45mA. This fault will be detected during run-time. Note! Antenna supervision only works above Ubatt=12.6V for the following HW assy: 2490025, 2551941, 2551942.

Possible cause

Antenna malfunction is triggered by any of the following conditions: - Faulty connector - Faulty wire harness - Faulty antenna U26

{ } Raw XML
diag