DAB Antenna short circuit to GND
Note! Make sure the battery voltage is above the limit of detection. Disconnect the DAB antenna power cord (black connector) from the antenna (U26) and check if the DTC becomes passive. If so replace the antenna (U26). If the DTC is still active then measure the wiring between ground and signal. The measurement result should be between 8 and 16 V. Diconnect the antenna from the infotainment system. If the DTC is still active then inspect the infotainment system for any issue (for example broken connector). If it becomes passive then the issue is in the wire. Inspect wire for any broken part or short circuit. Note. Before replacing the infotainment system update to the latest available software.
What you'll see
The infotainment system cannot receive signals from the antenna. No reception on the DAB radio.
System reaction
DAB might not work as expected
Diagnostic depth
If parameterSystem_DAB = on and DAB Antenna is short circuited to GND. When the current at the antenna > 45mA. This fault will be detected during run-time. Note! Antenna supervision only works above Ubatt=12.6V for the following HW assy: 2490025, 2551941, 2551942.
Antenna malfunction is triggered by any of the following conditions: - Faulty connector - Faulty wire harness - Faulty antenna U26