Camera2 Activation Short Circuit to UBAT
Disconnect the activation signal from the camera. Delete the DTC. Restart the infotainment system, activate camera2 and check if the DTC remains active. If so, check if the wire between the infotainment system and the camera activation signal (pin E10) has a short-circuit. Check any short-circuit for the remaining wiring between the camera and the infotainment system If it becomes passive the error probably depends on the camera. Check if the camera has internal short circuit. Note. Before replacing the infotainment system update to the latest available software.
What you'll see
The camera might not work. The infotainment system sends activation signal through pin E10 to camera2. If the activation pin is faulty the camera will not go into standby and consume current even though it's not used.
System reaction
No system-reaction text recorded.
Diagnostic depth
If the paramter Function_Camera2 = on and If the Camera2 Activation Line is Low and Line is shortened to UBAT. This fault will be checked in run-time but once the fault is SET the digital out line will be disabled. So, scanning of this fault will be stopped for that power cycle and again scanning of fault starts in the next power cycle.
Camera activation malfunction is triggered by any of the following conditions: - Faulty connector - Faulty wire harness - Faulty camera