DCC CAN StatusMessage and/or ActualMessage Fault from Slave 2
• Reset DTC • Toggle ignition key to "key off" and await system reset then "key on" i.e. system wake up. • Read out DTC's again • Check CAN circuit (e.g. cables and connectors) related to slave 2 • Replace cable harness if damaged
What you'll see
No driver-visible symptom recorded.
System reaction
Single DCC: • NA Master/slaves DCC: • DCC slave 2 will be disabled and enter standby. • DCC Master and other slave will provide charging depending on load.
Diagnostic depth
One of the following DCC2 events are active in DCC master: CAN.J1939D3StatusTimeoutError CAN.J1939D3StatusContentError CAN.J1939D3ActualTimeoutError CAN.J1939D3ActualContentError
• CAN Timeout or faulty content in actual or status message from DCC slave 2.