Write access to data flash failed.
Step.1: If Updated/Newer SW is available: Flash SW. Step-2: Perform proper Clamp_15-Reset with stable PowerSupply as follows: - Vehicle in Stand-Still (0kmph, Parking-Brake-Enganged) - Clampe_15_ON + wait 5 seconds - Clampe_15_OFF + wait 5 seconds - Clampe_15_ON + wait 5 seconds - If Error is still active (DTC-Status-TestFailed) remain with Step-3 Step-3: Replace the power pack if the SPN is still active.
What you'll see
Not applicable
System reaction
Set the Yellow Lamp to "On". Set the signal EASState to ERROR. Set the EPS motor torque to 0 Nm. Electronic steering system is inactive. The software endstops are deactivated. DTC, KFC_ERROR_MODE_ACTIVE is set ACTIVE in the same Klemme-15 cycle. ActualSteeringMode signal stay in ASM mode. Steering gear operational mode is in Disable Steering gear degradation reason is in Internal Fault Note:ASM functionality deactivate
Diagnostic depth
Internal Data Flash error.
1. Wrong software version flashed to powerpack. 2. Defective powerpack