S Scania Multi 📌 unpin — ▢ ×
Pin a chassis:
Home Vehicle Parts Information Workshop Diagnostics Search Back Forward Help
V
DTC › EMD0 EMD0 / 0400

Egr system faulty

â–¶ How to fix

Check the VGT and the EGR valve. Check if the EGR is mechanical restricted. Check for leakages in the gas exchange system. Check the MAF sensor Check the MAP/ boost pressure sensor Check the Boost temperature sensor Check the Exhaust pressure sensor For Eu5 vehicles: After repair run the " Checking the EGR system for devalidation of fault codes" . If the performance test could not finish for some reason, use the opportunity to erase NOx control DTC:s For Eu6 vehicles: After repair run the workshop test for adaptation of MAF or " Checking the EGR system for devalidation of fault codes".

What you'll see

No driver-visible symptom recorded.

System reaction

Engine performance might be affected.

Diagnostic depth

Detection

It is not possible to get the requested amount of EGR into the combustion. Mass flow sensor must be adapted and fuel injection must be higher than min limit.

Possible cause

The control of the EGR is not working properly. Possible faults are: EGR valve faulty. EGR restricted. VGT-actuator faulty. Leakage in the gas exchange system. MAF defective. MAP/ Boost pressure sensor defective Boost temperature sensor defective Exhaust pressure sensor defective

{ } Raw XML
diag