ID Heading MG
373 Retrieve the vehicle
374 Short test drive 1
376 In the maintenance area
384 Tilted cab
385 Under the vehicle
387 Raise the front axle and support with axle stands
388 Lower the front axle
389 At the front, sides and engine
390 Tyre tread depth
391 Short test drive 2
392 After test drive
394 (no heading)
401 Tilt the cab
407 Addition
428 Lower the cab
430 (no heading)
433 E1: Ethanol maintenance 1
435 Ethanol maintenance 2 (E2) includes E1
436 40,000 km intervals
438 Addition to S, M and L maintenance
440 Lower the cab
441 6 month intervals
442 12 month intervals
443 Form for R maintenance
444 X, S, M, L maintenance
445 Form for large pre-delivery inspection (D)
446 R, X, S, M, L maintenance
450 Action at the front and sides
451 In the cab
453 Before test drive
454 During test drive
455 After test drive
598 In the interior of the vehicle
604 In the engine compartment
614 Fire prevention check of the bodywork
622 In the maintenance area
640 Addition to L maintenance
873 Interior checks
874 Exterior checks
875 Doors
876 Climate system
959 To be performed using a computer
976 Outside the cab
977 For the chassis
978 Outside the cab
1002 Addition to M maintenance
1003 Truck
1005 Addition to Maintenance Plus
1007 Addition to X, XO, S and L maintenance
1013 Addition to M and L maintenance
1041 Form for R maintenance of exchange engine
1050 Actions on the roof
1095 Short test drive
1102 20,000 km intervals with Scania BEO-2 engine oil / 10,000 km intervals with Scania Bioethanol engine oil
1185 We have mineral oil or synthetic oil.
1233 For information about intervals using Scania BEO-2 engine oil, refer to preface 00:17-30
1243 Raise the front axle and support with axle stands
1244 Lower the front axle
1283 Tyre tread depth
1284 Under the vehicle
1442 To be performed using a computer
1443 In the cab
1444 Outside the cab
1445 For the chassis
1446 Tilted cab
1452 Preparation for maintenance
1543 In the engine compartment
1555 At the front, sides and engine
1556 In the interior of the vehicle
1588 Actions outside the vehicle
1665 This Vehicle Health Check form has been created to be used in the Scania Workshop Suite (SWS) application. In the long-term, SWS will replace Scania Multi and SDP3. For the time being, the Vehicle Health Check form is visible in Scania Multi.
1711 Actions to be performed with a connected vehicle
1712 Actions to be performed with a connected vehicle
1719 Fill engine oil through the oil filler pipe or through the cover in the rocker cover.
1726 Check the coolant level in the expansion tanks.
1758 If oil grade STO 1:1 G is used, the oil may need to be changed during M maintenance.
1759 If oil grade STO 1:0 is used, the oil may need to be changed during M maintenance.
132872 Safety check
132873 Before calibration
132874 Calibration and programming
132875 Internal
132876 External
132877 Underbody
132878 Test drive
132879 Finishing operations
132881 Chassis safety
132882 Articulation unit of articulated bus
132884 Emergency stop
132885 Safety check of the sensor function for the parking brake
132887 Electrical panel
132888 Rear electrical panel (articulated bus)
132889 BBFS form (Bus Bodybuilder Function Settings)
132890 Diagnostic socket
132891 ELC, electronic level control
132892 Resetting the link rod for the level sensor
132893 Distance sensor, DIS
132894 Forward looking camera, FLC
132896 Conversion
132898 BMS, Brake Management System
132899 Scania Communicator 300 - C300
132902 Operational testing of driver's seat
132905 Operational testing
132906 Lighting
132907 Plates and documentation
132908 Pedal panel and casings
132909 Inspection hatches and accessibility requirements
132917 Wheel
132918 Refuelling
132919 Fuel tank
132920 Cooling air intake
132922 Gas system
132923 Engine air intake
132924 Hatches and accessibility requirements
132926 Engine compartment ventilation
132927 Clearance in the engine compartment
132928 Engine compartment insulation
132929 Exhaust system
132930 Expansion tank
132931 Cooling system
132932 Air conditioning
132933 Heating system
132934 Auxiliary heater
132935 Hoses, pipes and cable harnesses
132936 Batteries
132937 Battery compartment
132938 Battery master switch
132939 Scania Communicator C300
132940 Electrical system body
132941 Emission control with reductant, SCR system
132942 Ventilation of fuel tanks and thermistor controlled
132943 Vehicle identification number, VIN code
132944 Cable harness
132945 APS unit
132946 Compressed air pipes
132947 Compressed air tanks
132950 Hydraulic pipes
132951 Painting and undersealing
132952 Air bellows
132953 Shock absorbers
132954 Chassis frame drill holes
132955 Weld joints in chassis frame
132956 Touch-up painting after welding
132957 Restrictions
132958 Attachment to rear module
132959 Front and rear frame parts
132960 Connection of front part of front module
132961 Horn
132962 Noise shield and encasing the engine compartment
132964 Test drive
132978 Automatic kneeling
132979 Bus stop brake
132984 Fault codes
141048 Tachograph and communication unit, SRC
142937 Safety check
142938 Before calibration
142939 Calibration and programming
142940 Internal
142941 External
142942 Underbody
142944 Test drive
142945 Finishing operations
142952 Chassis safety
143088 Articulation unit of articulated bus
143089 TPM, tyre pressure monitoring
143090 Emergency stop
143091 Safety check of the sensor function for the parking brake
143203 Transport connection
143222 Electrical panel
143803 Rear electrical panel (articulated bus)
143966 BBFS (bus bodybuilder function settings) form
143967 Diagnostic socket
143968 ELC, electronic level control
143969 Resetting link rod for level sensor
143970 Distance sensor, DIS2
143971 Forward looking camera, FLC
143972 Light sensor, LS
143973 Tachograph and communication unit, SRC
143991 Conversion
143994 SMS, Suspension Management System
143995 BMS, Brake Management System
143996 Scania Communicator 300-C300
143997 Distance sensor, DIS2
143998 Forward looking camera, FLC
143999 Operational testing of vibration motors in driver’s seat
144000 Light sensor, LS
144001 Finish
144002 Operational testing
144003 Lighting
144004 Plates and documentation
144005 Pedal panel and steering pillar
144006 Inspection hatches and accessibility requirements
144187 Electrohydraulic tag axle steering system (EST)
144595 Logotypes and symbols
144596 Wheel
144597 Refuelling
144598 Fuel tank
144599 Cooling air intake
144600 Fitting the radiator – N UA and N UB
144601 Gas system
144602 Engine air intake

Showing first 200; refine your filter to see more.