Workshop manuals ›
F, K and N-series
Document
- ID
- 9
- Business key
- REEB
- Type
- 77
Variant filter
1=B&1323=E
Activities 18
| ID | Heading | Component | MG | Filter |
|---|---|---|---|---|
| 1041 | Form for R maintenance of exchange engine false | 0 | — | |
| 344 | Check for gas leakage before running-in in the workshop false | Fuel system | 03 |
1=A&1323=E&520=C!1=A&1323=F&520=C!1=B&1323=E&520=C!1=B&1323=F&520=C
|
| 479 | Check that the vehicle is not leaking fuel before running-in in the workshop. false | Fuel system | 03 |
1=B&1323=E&520=B
|
| 1660 | Make sure that the starter key/starter button is in drive mode and that the function is deactivated via the switch for idle stop and start. false | Idle stop and start function | 16 |
1=A&1323=E&5526=A!1=A&1323=F&5526=A!1=B&1323=E&5526=A!1=B&1323=F&5526=A
|
| 1658 | Carry out Procedures for all workshop operations on hybrid vehicles before starting work. Information about these procedures can be found in the instructions. false | Hybrid vehicles | 00 |
1=A&1323=E&4034=B!1=A&1323=F&4034=B!1=B&1323=E&4034=B!1=B&1323=F&4034=B
|
| 473 | Read any fault codes. Delete the fault codes. false | Control units | 16 |
1=B&1323=E
|
| 534 | Check the oil level. Check for leakage. Fill with oil if necessary. false | Engine | 01 |
1=B&1323=E
|
| 611 | Renew the fuel filter and bleed the fuel system. Renew O-rings at the overflow valve on the fuel filter housing and clean the fuel strainer. false | Scania HPI fuel system | 03 |
1=B&1323=E&1470=C
|
| 582 | Adjust the preload on the unit injectors. false | Engine with Scania HPI | 01 |
1=B&1323=E&1470=C
|
| 542 | Check and adjust valve clearance. Intake valve: 0.45 mm and exhaust valve: 0.70 mm. false | Engine | 01 |
1=B&1323=E&142=B&520=A!1=B&1323=E&142=D&520=A!1=B&1323=E&142=E&520=A!1=B&1323=E&142=H&520=A
|
| 543 | Check and adjust valve clearance and unit injectors. Intake valve: 0.45 mm and exhaust valve: 0.70 mm. false | Engine | 01 |
1=B&1323=E&520=B
|
| 1017 | Check and adjust valve clearance. Intake valve: 0.45 mm and exhaust valve: 0.80 mm. false | Engine | 01 |
1=B&1323=E&520=C
|
| 1024 | Check and adjust valve clearance. Intake valve: 0.25 mm and exhaust valve: 0.65 mm. false | Engine DC07 | 01 |
1=B&1323=E&142=K
|
| 581 | Check spring heights of unit injectors and adjust if required. false | Engine with PDE | 01 |
1=B&1323=E&520=A&1470=B
|
| 1691 | For vehicles with LNG fuel: Use coolant with a freezing point of -38°C or lower. This corresponds to a minimum of 50% addition of coolant concentrate with corrosion protection in the coolant. false | 0 |
1=A&1323=E&5841=B!1=A&1323=F&5841=B!1=B&1323=E&5841=B!1=B&1323=F&5841=B
|
|
| 904 | Check the fluid level. false | Cooling system | 02 |
1=B&1323=E
|
| 474 | Read any fault codes. Delete the fault codes. false | Control units | 16 |
1=B&1323=E
|
| 1657 | Carry out Procedures for all workshop operations on hybrid vehicles after the work has been completed. Information about these procedures can be found in the instructions. false | Hybrid vehicles | 00 |
1=A&1323=E&4034=B!1=A&1323=F&4034=B!1=B&1323=E&4034=B!1=B&1323=F&4034=B
|
Change history (sv-SE)
2024-09-11: Tagit bort admonition om kylvätskekoncentration för framdrivningsbatterier i och med att berörd punkt inte finns. [bib] 2023-12-07: Ny admonition om kylvätskekoncentrationen för fordon med framdrivningsbatterier. [bib] 2023-10-06: Lagt till admonition med info om kylvätskemix för LNG-fordon. [bib] 2019-09-05: Lagt till admonitions för stopp-start, rutiner vid arbete med hybrid och stänga av gastillförseln. 2013-10-15: Vi får göra 2 separata protokoll eftersom fältet Fordonstyp måste vara ifylld för att protokollet ska synas i Multi. 2013-09-20: Beslut vi arbetsmöte september 2013 att vi gör protokollet giltigt även för buss med anledning av FQ-ärende. Vi tar bort rubriker som är fordonsspecifika. 2012-02-17: Uppdaterat R-tillsyn. [bib] 2011-11-04: Uppdaterat rubrikerna. [sssbib] Lagt till om villkor för R-tillsyn. [bib] 100303, vi har tagit bort punkten om byte av det rammonterade bränslefiltret eftersom det inte förekommer tillsammans med HPI. 090303, vi har lagt till det vätskeavskiljande bränslefiltret samt om elektroniska styrenheter. 070713, vi har lagt R-tillsynen för bytesmotorer som ett eget dokument.