Current HW coding differs from initial coding - FM (Frequency Modulated) / PWM (Pulse Width Modulated) Failure
â–¶ How to fix
Check wiring connector
What you'll see
None
System reaction
None
Diagnostic depth
Detection
- Pin configuration was changed from master to slave or vice versa - DID 011D (Amount of EVCC) is set to 0 (1 EVCC installed) and pin configuration is set to Slave - DID 011D (Amount of EVCC) is set to 0 (1 EVCC installed) and pin configuration is set to Master and CAN messages are received onf the private CAN bus - Both pins are not connected - Both pins are connected to GND
Possible cause
- Configuration was changed from master to slave or vice versa