DIS2 node inconsistent configuration.
Spare part program the units which are not configured correctly.
What you'll see
• Undefined vehicle behavior (if an ECU configuration does not match the vehicle) • Logging of operation data is disabled when the DTC is active.
System reaction
No system-reaction text recorded.
Diagnostic depth
The DTC is set active if one of the following conditions is fulfilled: • A faulty chassis number is sent by the DIS2, at least 9 times (msg period time is 5 s --> 9*5 = 45 s). • The CAN message GPM1_DIS has been absent for 135 seconds (9*15 = 135 s time-out) • A chassis number has been sent by DIS2, but the DAS vehicle configuration (EOL) does not include an DIS2 (msg period time is 5 s --> 9*5 = 45 s) The DTC is set inactive when none of the above listed conditions are fulfilled. The DTC is not set in the following cases: • Ignition is turned off (*) • First 2 seconds after ignition on (*) • System voltage is below 22 volt (*) • System voltage is above 32 volt (*) • Communication from DIS2 node is interrupted (separate DTC) (*) Only used to inhibit DTC for GeneralPurposeMessage time-out.
• The DIS2 unit is not correctly configured - Spare part unit, which has not been programmed/configured - Unit transferred from another vehicle • The DAS unit is not correctly configured - Spare part unit, which has not been programmed/configured - Unit transferred from another vehicle