Power exceeded for POWER_OUT_1 (unconnected). TO BE REMOVED
Measure the resistance between DAS2(pin A28) and DIS. Check cable harness between DAS2(pin A28) and DIS. Remove DIS and measure resistance between DAS2 pin A28 and ground. The resistance should be high between DAS2 pin and ground, otherwise there is a short-circuit to ground.The resistance between DAS2 pin A28 and the power supply pin in the DIS connector should however be close to 0 ohms to secure an appropriate supply. Change sensor.
What you'll see
No driver-visible symptom recorded.
System reaction
None.
Diagnostic depth
The DTC is set active if one of the following conditions are met: - The current supplied at Power output 1 (power output for DIS2) is too high (>2.5A) for 1s, while the signal status of current sense is good. - The current supplied at Power output 1(power output for DIS2) is too high (>0.8A) for 6s, while the signal status of current sense is good and the test condition ALL_ECU_ON is set to true. The DTC is not set in the following cases: - Ignition is turned off. - First 2 seconds after ignition on. - System voltage is below 22V - System voltage is above 32V
Faulty cable connecting Power output 1 (POWER_OUT_1) Short circuit to ground.