FLC Not Connected TO BE REMOVED
Measure the resistance between DAS2(pin A30) and FLC. Check cable harness between DAS2(pin A30) and FLC. Remove FLC and measure resistance between DAS2 pin A30 and ground. The resistance should be low between DAS2 Connectors, and high between two different pins in the same connector. Change sensor.
What you'll see
Other DTC could be set as a consequence of sensor not getting enough power
System reaction
No system-reaction text recorded.
Diagnostic depth
The DTC is set active if the following conditions are met: - NP_FORWARD_LOOKING_CAM == 10 - ALL_ECU_ON is true - The current supplied at power output 3 (power output for FLC) is too low (<0.02A) for 6s while the signal status of current sense is good. The DTC is not set in the following cases: - Ignition is turned off. - First 2 seconds after ignition on. - System voltage is below 22V - System voltage is above 32V
Faulty cable connecting Power output 3 (POWER_OUT_3) Not connected while EOL setting says it should be connected. Short circuit to ground.