SRR Right Not Connected
Measure the resistance between DAS2(pin A31) and SRR right. Check cable harness between DAS2(pin A31) and SRR right. Remove SRR right and measure resistance between DAS2 pin A31 and ground. The resistance should be low between DAS2 Connectors, and high between two different pins in the same connector. For SRR Right, remove forward looking side-radar and check if it solves issue. Checking this by looking at the CAN signals, if it can communicate with diagnostics. Change sensor.
What you'll see
Other DTC could be set as a consequence of sensor not getting enough power.
System reaction
No system-reaction text recorded.
Diagnostic depth
The DTC is set active if the following conditions are met: - NP_SIDE_RADAR_RIGHT == 10 - ALL_ECU_ON is true - The current supplied at power output 4 (power output for SRR right) is too low (<0.02A) for 6s while the signal status of current sense is good. The DTC is not set in the following cases: - Ignition is turned off. - First 2 seconds after ignition on. - System voltage is below 22V - System voltage is above 32V
Faulty cable connecting Power output 4 (POWER_OUT_4) while EOL setting says it should be connected Short circuit to ground