Signal, ExternalControlModeRequest out of defined range
â–¶ How to fix
Step-1: Perform a Klemme-30 reset (Power Reset). Step-2: If the DTC is still active, check the sending ECU(s).
What you'll see
Not applicable
System reaction
De-activate External Assist Interface functionality. Hint: The functionality Active Lane Assist (EAI) provides an interface for controlling the wheel angle via CAN..
Diagnostic depth
Detection
The DTC will set during the following condition: 1.ExternalControlModeRequest signal has a value between the range, [0x6, 0xE]. 2.system state: NMWait, PreDrive, DriveDown, DriveUp, PostRun, Off, Error, Flash, LowVolt. 3.system voltage is above 16v. 4.system voltage is below 32v.
Possible cause
The received signal value is in one of the below mentioned value ranges: 0x06-->0x0D - Undefined 0xE - Reserved