Signal, CurrentGear defined out of range
â–¶ How to fix
Step-1: Perform a Klemme-30 reset (Power Reset). Step-2: If the DTC is still active, check the sending ECU(s).
What you'll see
Not applicable
System reaction
The DTC will allow to work with diagnostics programming and diagnostic reset. No applicable system reactions/possible effects.
Diagnostic depth
Detection
The DTC will set during the following condition: 1.system state: NMWait, PreDrive, DriveDown, DriveUp, PostRun, Off, Error, Flash, LowVolt. 2.system voltage is above 16v. 3.system voltage is below 32v. 4. Signal, CurrentGear has a value between the range, [0xFC, 0xFE]
Possible cause
The received signal value is in one of the below mentioned value ranges: 1. 0xFB - PS (Parameter Specific) 2. 0xFC & 0xFD - RES (Reserved) 3. 0xFE- ERR (Error)