NVSHARE data not available
â–¶ How to fix
Replace the power pack.
What you'll see
The driver might detect reduction in Assistance/Hard Steering due to reduced electrical support.
System reaction
Set the Yellow Lamp to "On". Set the signal EASState to ERROR. Set the EPS motor torque to 0 Nm. Electric steering system is inactive. Software endstops are deactivated. DTC, KFC_ERROR_MODE_ACTIVE is set ACTIVE in the same Klemme-15 cycle.
Diagnostic depth
Detection
The DTC will set during the following condition: 1.system state: PreDrive, DriveDown, DriveUp, PostRun, Error. 2.system voltage is above 6v. 3.system voltage is below 42v.
Possible cause
1. Defective powerpack. 2. Internal ECU error. Note: Data Block initiation failure at startup of ECU.