Signal, EASSteerWheelVibrStrength out of defined range
â–¶ How to fix
Step-1: Perform a Klemme-30 reset (Power Reset). Step-2: If the DTC is still active, check the sending ECU(s).
What you'll see
Not applicable
System reaction
No applicable system reactions/possible effects.
Diagnostic depth
Detection
The DTC will set during the following condition: 1.EASSteerWheelVibrStrength signal has a value between the range, [0xFB, 0xFE]. 2.system state: NMWait, PreDrive, DriveDown, DriveUp, PostRun, Off, Error, Flash, LowVolt. 3.system voltage is above 16v. 4.system voltage is below 32v.
Possible cause
The received signal value is in one of the below mentioned value ranges: 0xFB - Parameter Specific 0xFC - Reserved 0xFD - Reserved 0xFE - Error 0xFF - SNA (Signal-Not-Available).