Check wiring and connectors between the EST::ECU (E112) and EST::CVU::CPS (T184). The battery should be disconnected during measurements. Check if CPS (T184) has fysical damage, if so replace it. If no obvious error use procedure below to find where the error is. If the below procedure don't indicate errors on connectors and cable harness; replace CPS(T184). 1. Check CAN cable harness and connectors: - Disconnect harness connectors on both ECU side, and CPS side. - Measure the resistance in the cable between pins E112::A35 and T184::4. It should be approximately 0 ohm (no interruption or bad connection). - Measure the resistance in the cable between pins E112::A38 and T184::2. It should be approximately 0 ohm (no interruption or bad connection). - Measure the resistance in the cable between each single wire. It should be infinite (no short circuit). - Visually inspect the isolation along the entire cable length, for abrasion damage that could lead to a short circuit against frame or similar. 2. Check power supply to CPS: - Disconnect harness connectors on both ECU side, and CPS side. - Measure the resistance in the cable between pins E112::A3 and T184::5. It should be approximately 0 ohm (no interruption or bad connection). - Measure the resistance in the cable between pins E112::A1 and T184::3. It should be approximately 0 ohm (no interruption or bad connection). - Measure the resistance in the cable between each single wire. It should be infinite (no short circuit). - Visually inspect the isolation along the entire cable length, for abrasion damage that could lead to a short circuit against frame or similar. 3. Check CPS connector housing and sensor: - Disconnect harness connector only on ECU side, and measure the resistance between pins E112::A35 and E112::A38. It should be approximately 120 ohm (termination resistor in CPS). - If OK ==> Reconnect ECU connector - If NOK ==> Replace CPS connector housing, and reperform measurement (3) 4. Check ECU: - Disconnect harness connector only on CPS side, and measure the resistance between pins T184::2 and T184::4. It should be approximately 120 ohm (termination resistor in ECU). Verify that the issue is solved by performing a Diagnostic SelfTest (requires Parking Brake to be applied) - If the root cause fault has been fixed, this DTC will be set passive.

Diagnostic depth