DTC ›
SGC1
| Code | Heading | Variants |
|---|---|---|
| 0350 | ECA - CAN timeout from ECA | — |
| 035A | ECA - Error on Actual Position signal | — |
| 0364 | ECA - Error on Actual Position Displacement Sensor signal | — |
| 0378 | ECA - ECA does not receive CAN messages from the gearbox control unit | — |
| 0382 | ECA - Slave cylinder is outside the permissible range | — |
| 0396 | ECA - Circuit board temperature is too high | — |
| 03A0 | ECA - Risk of overheating driver stages | — |
| 03AA | ECA - Fault in angle position sensor | — |
| 03B4 | ECA - Supply voltage too low | — |
| 03BE | ECA - Supply voltage low | — |
| 03DD | ECA - Detection of clutch slipping with clutch closed | — |
| 03DE | ECA - Implausible clutch wear | — |
| 03E6 | ECA - Faulty clutch movement | — |
| 03F0 | ECA slave cylinder - Movement is too short to achieve full disengagement | — |
| 03F1 | ECA slave cylinder - Movement is shorter than expected but adequate to disengage | — |
| 03FA | ECA - Fluid level too low | — |
| 0404 | ECA - Fault in electric motor | — |
| 0C00 | Manual clutch position sensor - Reading stuck open | — |
| 0C01 | Manual clutch position sensor - Not calibrated | — |
| 1393 | Battery over voltage | — |
| 1394 | Battery under voltage | — |
| 139D | Critical internal fault in the control unit (CRC checksum faulty) | — |
| 13B0 | Non-critical internal fault in the control unit (CRC checksum faulty) | — |
| 13C0 | Internal temperature measurement (cold side) | — |
| 13C1 | Internal temperature measurement (wam side) | — |
| 13C2 | Outputs are disabled due to error on Output Enable Watchdog. | — |
| 13C3 | Power Hold function is not enabled when it should be. | — |
| 272E | The control unit does not have a valid configuration. | — |
| 272F | Incorrect splitter gear ratio | — |
| 2AF8 | False neutral indication when engine control | — |
| 2AF9 | Falsk neutralkvittens vid stillastående | — |
| 2B20 | Timeout on messages from the engine control unit on CAN | — |
| 2B21 | Timeout on EEC1 message on CAN | — |
| 2B34 | Timeout on EBC message on CAN | — |
| 2B50 | Timeout on HRVD message on CAN | — |
| 2B51 | Timeout on SP message on CAN | — |
| 2B52 | Timeout on TCU2 message on CAN | — |
| 2B53 | Timeout on TCU4 message on CAN | — |
| 2B54 | Timeout on TD message on CAN | — |
| 2B55 | Timeout on TCU6 message on CAN | — |
| 2B56 | Timeout on TCO1 message on CAN | — |
| 2B57 | Timeout on AC message on CAN | — |
| 2B58 | Timeout on DIAG message on CAN | — |
| 2B59 | Timeout on TCU8 message on CAN | — |
| 2B5A | Timeout on TSC1 message on CAN | — |
| 2B5F | Bus off on main CAN | — |
| 32C8 | Rotational speed sensor for main shaft - Open circuit | — |
| 32C9 | Rotational speed sensor for main shaft - Short circuit to ground | — |
| 32CA | Rotational speed sensor for main shaft - Short circuit to battery | — |
| 32CB | Rotational speed sensor for main shaft - Incorrect or unreliable data | — |
page 1 of 5
next →